Cost Guides · 2026

Roof Tear-Off and Replacement Cost Calculator (2026)

Tear-off runs $39–$53 per square per layer for shingles in our 2026 model. Tearing off and replacing a 2,000 sq ft house roof: about $14,000–$18,500.

$39–$53

Short answer

Tear-off runs $39–$53 per square per layer for shingles in our 2026 model. Tearing off and replacing a 2,000 sq ft house roof: about $14,000–$18,500.

Roof tear-off cost in 2026

Tearing off an old roof costs $39–$53 per roofing square per layer for asphalt shingles in TheRoofBill's 2026 model. A 2,000 sq ft house has about 2,240 sq ft of roof (22.4 squares) at a medium pitch, so one layer comes to about $870–$1,190 and two layers about $1,750–$2,370. Heavier roofs cost more to remove: $50–$85 per square for metal, $55–$90 for wood shake and $60–$95 for tile or slate.

Tearing off and replacing the roof is a different number. In the model's national baseline example, the same 2,000 sq ft house costs about $14,000–$18,500 with architectural shingles, tear-off included, or roughly $625–$825 per square all-in. The full-project matrix below breaks that out by material.

Calculator

Roof tear-off cost calculator

Price removing the old roof, or check whether an overlay (reroof without tear-off) is even allowed.

01

Tear off or overlay?

02

Roofing being removed

$39–$53 per roofing square per layer.

03

Roof area

Area unit

22.4 roofing squares. A 2,000 sq ft house with a medium pitch has about 2,240 sq ft of roof.

04

Existing layers

Lift a shingle at the edge, or check the drip edge, to count layers.

Planning estimate

Tear-off cost

Asphalt shingles · 1 layer · 2,240 sq ft

Tear-off labor

$870–$1,190
Per square$39–$53
Squares22.4
Permits + disposal$300–$480

The model prices permits and disposal together at $300–$480 for the whole job. Decking found rotten after tear-off is extra; the full calculator adds a 10% allowance.

Tear-off cost by roofing type

Roofing removedPer square, per layer2,000 sq ft house (22.4 squares), one layerOverlay allowed?
Asphalt shingles$39–$53$870–$1,190Once, if dry and sound
Metal panels$50–$85$1,120–$1,910Sometimes, per manufacturer
Wood shake$55–$90$1,230–$2,020Check local rules
Clay or concrete tile$60–$95$1,340–$2,130No
Slate$60–$95$1,340–$2,130No
Flat membrane$40–$60$890–$1,350Depends on the system

Rates are the model's tear-off inputs from our methodology. Permits and disposal are a separate $300–$480 line for the whole job.

Tear-off only vs tear off and replace: the full project

Most people searching for tear-off cost are pricing the whole job: remove the old roof, then install a new one. The tear-off is a small share of that bill. The matrix uses the same national baseline example for every row: a 2,000 sq ft one-story footprint (about 2,240 sq ft of roof, 22.4 squares), medium pitch, simple gable, labor factor 1.00, one layer removed, the $300–$480 permit and disposal allowance and a 10% decking contingency.

New roof (old roof of the same type removed)Tear-off lineFull tear-off and replacementAll-in per squareTear-off share of the job
3-tab asphalt$874–$1,187$11,000–$16,500$492–$734About 7.5%
Architectural asphalt$874–$1,187$14,000–$18,500$625–$825About 6.3%
Architectural asphalt, two layers removed$1,747–$2,374$14,900–$19,700$664–$878About 12%
Standing seam metal$1,120–$1,904$26,100–$41,800$1,163–$1,866About 4.5%
Concrete tile$1,344–$2,128$26,300–$42,000$1,173–$1,876About 5.1%
Natural slate$1,344–$2,128$38,600–$71,600$1,723–$3,196About 3.2%

Totals are rounded to the nearest $100; the tear-off share compares the midpoints of the tear-off line and the total. The metal row assumes metal is being removed. Tearing off asphalt shingles to install metal uses the shingle rate instead, so its tear-off line would be about $874–$1,187 and the total slightly lower. For your own state, pitch and layer count, use the roof replacement cost calculator; for the effect of house size, see roof replacement cost by house size.

Tear-off is one of the least consistent lines across cost guides, mostly because some include disposal and some don't. Checked November 13, 2026:

SourceShingle tear-off figureDisposal included?
TheRoofBill model$39–$53 per square per layerNo: separate $300–$480 permit and disposal line
Fixr, roof replacement cost (2026 data)About $50 per square on average; up to $150 for heavy materials or multiple shingle layersYes, dumping fees included
HomeGuide, roofing labor cost$1–$3 per sq ft for shingles or metal ($100–$300 per square); $2–$5+ for slate or tileNot stated

Our rate sits near Fixr's average and well below HomeGuide's range. A bid that prices tear-off at $100 or more per square is not automatically padded, especially if it includes disposal, more than one layer or a steep roof. What matters is that the bid states the rate, the layer count and what disposal costs.

Disposal and dumpster costs

Shingle debris has to go somewhere, and someone pays for the container and the landfill. Budget Dumpster's shingle disposal guide lists, as national figures:

  • 10-yard dumpster: $394 on average, from $227 to $579
  • 20-yard dumpster: $447 on average, from $264 to $687
  • Hauling shingles yourself: $32–$40 per ton at most landfills, before truck rental, fuel and time

Roll-off rentals usually include a weight allowance and bill per ton over it, and shingles are dense. Ask your roofer whether the container, any overweight charges and a street-placement permit are inside the price. On a contractor's job, disposal is normally the roofer's responsibility; you shouldn't need to rent a dumpster yourself unless you're doing the tear-off.

Overlay vs tear-off: when the code decides for you

An overlay, or recover, lays new shingles over the old layer. It saves the removal cost, but the residential code limits it. Section R908.3.1.1 of the International Residential Code, as quoted in the City of Des Moines reroofing requirements, does not permit a recover where the existing roof is water-soaked or has deteriorated, or where it already has two or more applications of roofing. The same section of the code also rules out covering slate, clay, cement or asbestos-cement tile. Some states and towns are stricter; New Jersey's edition, for example, does not allow a third layer.

Tear-offOverlay
Upfront costHigher: adds $870–$1,190 per shingle layer on a 2,000 sq ft houseLower
Decking inspected and repairedYesNo, it stays hidden
Ice barrier and flashing replaced at the deckYesLimited
Weight on the framingOld weight removedAdds a layer
Next reroofOne layer to removeTwo layers to remove

A tear-off is usually the better buy when the budget allows, because rotten decking found now costs less than a leak through it later. If you do overlay, ask the roofer to confirm the shingle maker's warranty applies to an overlay installation.

For the full set of code limits, warranty and insurance risks, and a step-by-step way to decide, see our guide to roofing over existing shingles.

What a tear-off bid should list

  • Layers counted, and the per-square rate for each.

  • Disposal: dumpster, haul-away and landfill fees, and whether they are in the tear-off line.

  • Decking: a per-sheet price for replacing rotten boards once the roof is off. The full calculator adds a 10% decking allowance for this.

  • Protection: tarps over landscaping and magnetic sweeps for nails.

  • Decking: see roof decking replacement cost for typical per-sheet prices and how far the allowance goes.

For the whole job, use the roof replacement cost calculator with your layer count, check the labor side with roofing labor cost per square, compare bids with our roofing estimate red flags, and browse the other 2026 roof cost guides.

Sources: TheRoofBill methodology for every model figure; Fixr, HomeGuide and Budget Dumpster as linked above; IRC section R908.3.1.1 as quoted by the City of Des Moines and the Florida Building Commission. Checked November 13, 2026.

The next step

Get your number in 60 seconds.

Answer a few quick questions and get an itemized 2026 estimate for your roof. No email, no sales calls.

Open the Roof Cost Calculator →

Based on 2026 public cost data. See the methodology.

Frequently asked questions

What is the average cost to tear off and replace a roof?

In TheRoofBill's 2026 national baseline example, tearing off one layer and installing architectural shingles on a 2,000 sq ft one-story house (about 2,240 sq ft of roof) costs about $14,000–$18,500, or roughly $625–$825 per roofing square all-in. The tear-off itself is only about $870–$1,190 of that. 3-tab shingles bring the same job to about $11,000–$16,500.

How much does a roof tear-off cost in 2026?

TheRoofBill's 2026 model uses $39–$53 per roofing square (100 sq ft) per layer to remove asphalt shingles, $50–$85 for metal, $55–$90 for wood shake and $60–$95 for tile or slate. On a 2,000 sq ft house with about 2,240 sq ft of roof, one shingle layer comes to about $870–$1,190.

How does the roof tear off cost calculator work?

Choose what's being removed, enter the roof area in square feet or roofing squares and the number of layers. The calculator multiplies squares by the per-square rate and layers. Switch to overlay to see whether the code allows skipping the tear-off and what that would save.

Is there a reroof cost calculator?

Yes. A reroof is usually a full replacement, tear-off included. Use the tear-off calculator on this page for the removal, and our roof replacement cost calculator for the whole job: materials, labor, tear-off, permits and a decking allowance.

Is an overlay cheaper than a tear-off?

Up front, yes: you skip the removal, which runs about $870–$1,190 for one shingle layer on a 2,000 sq ft house in our model. But the residential code bans an overlay over two or more layers, over slate, clay or cement tile, and over a water-soaked or deteriorated roof, and an overlay hides decking you can't inspect.

Does tear-off cost more with two layers?

Yes, roughly double: the model charges the per-square rate for each layer. Two shingle layers on a 2,000 sq ft house come to about $1,750–$2,370 to remove.

Is disposal included in the tear-off price?

In our model, permits and disposal are a separate combined line of $300–$480 for the job. Some guides fold dumping into the tear-off rate instead: Fixr cites about $50 per square including dumping fees. Ask each roofer whether the dumpster and landfill fees are inside the tear-off price or listed separately.

Cost figures are planning estimates based on 2026 public data (Homewyse, Angi, Fixr, BLS). They are not contractor quotes. Full disclaimer · How we calculate.