Cost Guides · 2026

Roof Decking Replacement Cost (2026): Plywood, OSB & Labor

Roof decking replacement runs about $2–$5 per sq ft installed, or roughly $64–$160 per 4×8 sheet. Convert damaged area to sheets and check a bid's decking line.

$2–$5

Short answer

Roof decking replacement runs about $2–$5 per sq ft installed, or roughly $64–$160 per 4×8 sheet. Convert damaged area to sheets and check a bid's decking line.

Calculator

Roof cost calculator

Preset to the national labor baseline and a 2,000 sq ft home (2,240 sq ft of roof). Change any input for an itemized 2026 estimate. The link in your address bar saves your inputs.

01

Material

Model rate: $5.21–$6.82 per roof sq ft installed.

02

Roof area

Area unit

Roof surface, not floor area. One roofing square = 100 sq ft. 2,240 sq ft = 22.4 squares.

03

Roof pitch

Steeper roofs take more labor and safety setup.

04

Complexity

05

Stories

06

Old layers to tear off

Tear-off: $39–$53 per square per layer.

07

Location

State labor factor from BLS roofer wages. ZIP is optional and never stored.

+

Extras (optional)

Itemized planning estimate

Your roof bill

National baseline · 2,240 sq ft roof

Planning estimate
Materials & installation2,240 sq ft × $5.21–$6.82 × 1.00 adjustments$11,670–$15,280
Tear-off22.4 squares × $39–$53 × 1 layer$870–$1,190
Permits & disposalModel default, scaled to 1.6× at the high end$300–$480
Decking contingency10% of base, for damaged decking found mid-job$1,160–$1,530

Estimated installed total · Architectural Asphalt Shingles

$14.0k–$18.5k
Low$14,000
Typical (midpoint)$16,200
High$18,500

$630–$820 per roofing square, all in. Planning life 25–30 years.

Not included: gutters and structural repairs beyond decking.

Planning estimate only, not a contractor quote. Actual cost depends on roof condition, local requirements, and the work included.

Roof decking replacement cost: the short answer

Replacing roof decking (the plywood or OSB under the shingles) costs about $2–$5 per square foot installed in HomeGuide's decking guide, checked November 13, 2026. A standard 4×8 sheet covers 32 sq ft, so that range works out to roughly $64–$160 per sheet installed. Angi's 2026 roof sheathing guide gives a wider $2–$6 per square foot and a $6,400 national average for full sheathing installation.

The short answer

Most reroofs replace a few damaged sheets, priced per sheet once the old roof is off. Ask every roofer for a written per-sheet price before you sign. Full deck replacement on a typical 2,240 sq ft roof (about 70 sheets) runs roughly $4,480–$11,200 at HomeGuide's installed range.

What roof decking is

Decking, also called sheathing, is the layer of wood panels or boards fastened to the rafters or trusses. Shingles, underlayment and flashing are nailed into it, so the deck has to be solid and dry.

For asphalt shingles, the International Residential Code (section R905.2.1) requires a solidly sheathed deck, as the City of Brandon's 2021 IRC roofing guide quotes it. That matters for older homes: spaced boards left from an old wood shake roof (skip sheathing) can't take shingles directly, so converting from shakes to shingles usually means adding solid sheathing over the whole roof. Your local building department decides which code edition applies.

Decking cost per sheet: convert damaged area to sheets

The table converts damaged area into 4×8 sheets and applies HomeGuide's ranges. It is simple arithmetic so you can check a bid, not a TheRoofBill model output.

Damaged area4×8 sheetsInstalled ($2–$5/sq ft)Plywood material only ($16–$64/sheet)Labor ($1.50–$3.00/sq ft)
32 sq ft1$64–$160$16–$64$48–$96
160 sq ft5$320–$800$80–$320$240–$480
320 sq ft10$640–$1,600$160–$640$480–$960
640 sq ft20$1,280–$3,200$320–$1,280$960–$1,920
2,240 sq ft (full deck)70$4,480–$11,200$1,120–$4,480$3,360–$6,720

Sheets are rounded up, since a roofer can't buy part of one. HomeGuide's OSB range is $9–$60 per sheet before installation; its tongue-and-groove range is $48–$83. The installed column already includes material and labor, so don't add the other two columns to it.

Partial vs full decking replacement

Partial replacement is the normal case on a reroof. With the shingles off, the crew walks the deck, marks soft or delaminated sheets, cuts them out at the rafters and nails in new panels. Because tear-off and access are already paid for, the per-sheet price is usually the cheapest it will ever be.

Full replacement happens when damage is widespread, when the existing boards don't meet the solid-deck rule, or when a heavier roof needs a stiffer deck. Angi notes that sheathing damage usually spreads across a wide area once water gets in, and that a separate repair means removing the roofing first, so full replacement is often more cost-effective than patching.

SituationTypical scopeHow it's usually priced
A few soft spots found during tear-offPartialPer sheet, on a change order
Large stained or sagging areasPartial to fullPer sheet, or per sq ft above a threshold
Skip sheathing under an old shake roofFull overlay of solid panelsPer sq ft for the whole roof
Heavier new roof (tile, slate)Engineer or code review firstSeparate line; ask the roofer

Hidden rot and the decking contingency

You can't fully see the deck until the roof is off, so budget for it in advance. TheRoofBill's roof replacement cost calculator adds a 10% decking contingency to every estimate. On the model's national baseline example for a 2,000 sq ft one-story footprint with architectural shingles (2,240 sq ft of roof), that allowance is about $1,167–$1,528.

How far does that go? At HomeGuide's $64–$160 per installed sheet, $1,167–$1,528 covers roughly 7 to 24 sheets, depending on where your local price falls. Fewer damaged sheets means the allowance goes unused; a roof with widespread rot or skip sheathing can exceed it. We don't publish a typical number of bad sheets per roof: no source we trust measures it, and it depends heavily on the roof's age, ventilation and leak history.

Rot at the eaves often runs into the fascia board too; see fascia and soffit replacement cost for that part of the repair.

Signs your roof decking may need replacing

From the outside and the attic, before anyone pulls shingles, HomeGuide lists these warning signs:

  • Flaky, spongy or soft wood when you press on the deck from the attic
  • Frequent roof leaks in the same area
  • Discoloration or mold on the underside of the deck
  • A strong mildew smell in the attic
  • A sagging roofline or ceiling
  • Moisture or stains on ceilings, walls or rafters

Daylight through the deck boards, nails that have backed out, and a deck that feels bouncy under a roofer's feet are things a roof inspection can confirm. If you see signs of structural sagging, rafters or trusses may need repair, which is a separate job from decking.

Worked examples by scope

All three use the model's national baseline replacement for a 2,000 sq ft one-story footprint (2,240 sq ft of roof, architectural shingles, one layer removed): about $14,000–$18,500, which already includes the 10% decking allowance.

  1. Five bad sheets found at tear-off. HomeGuide's range puts five sheets at $320–$800, well inside the allowance. Your final bill shouldn't rise for decking.
  2. Twenty bad sheets around an old chimney leak. About $1,280–$3,200 at HomeGuide's range. Depending on your roofer's sheet price, this may fit inside the allowance or exceed it by as much as about $2,000.
  3. Skip sheathing under a shake roof being converted to shingles. About 70 sheets over the whole roof, $4,480–$11,200. Plan this as its own line from day one rather than relying on a contingency.

Labor and materials vary by market. Use these to check whether a bid's decking line is in a plausible range, not as a price for your roof.

Decking red flags on a roofing quote

  • No per-sheet price at all. You're agreeing to an open-ended charge. Get the price, the panel type and its thickness in writing.
  • "Replace all decking" on every bid, with no inspection. Full replacement can be right, but the reason should be stated (skip sheathing, widespread damage, a code requirement).
  • No approval step. The contract should say the roofer will show you, or photograph, the damaged sheets and get your sign-off before adding them.
  • A count that can't be checked. Ask for photos and the number of sheets replaced on the final invoice.

Compare bids line by line with our roofing estimate red flags and the roof tear-off cost guide.

The next step

Get your number in 60 seconds.

Answer a few quick questions and get an itemized 2026 estimate for your roof. No email, no sales calls.

Open the Roof Cost Calculator →

Based on 2026 public cost data. See the methodology.

Sources and fact-check date

Checked November 13, 2026:

  • HomeGuide, cost to replace roof decking: installed per-sq-ft range, labor, per-sheet material ranges, signs of damage. The page shows no update date.
  • Angi, roof sheathing cost: 2026 national average, per-sq-ft range by sheathing type, repair vs replacement notes.
  • City of Brandon, 2021 IRC roofing guide: IRC R905.2.1 solid sheathing requirement for asphalt shingles.
  • TheRoofBill methodology: national baseline replacement inputs and the 10% decking contingency.

More project costs are in our 2026 roof cost guides.

The next step

Get your number in 60 seconds.

Answer a few quick questions and get an itemized 2026 estimate for your roof. No email, no sales calls.

Open the Roof Cost Calculator →

Based on 2026 public cost data. See the methodology.

Frequently asked questions

How much does it cost to replace roof decking in 2026?

HomeGuide puts installed roof decking replacement at $2–$5 per square foot, and Angi's 2026 sheathing guide gives $2–$6 per square foot with a $6,400 national average for full installation. A standard 4×8 sheet covers 32 sq ft, so $2–$5 per square foot works out to about $64–$160 per sheet installed. Most reroofs replace only the damaged sheets, not the whole deck.

What is the labor cost to replace roof decking?

HomeGuide lists decking labor at $1.50–$3.00 per square foot, or $45–$75 per hour. Per 4×8 sheet that is about $48–$96 of labor. Replacing sheets during a reroof is cheaper than a separate repair because the shingles are already off.

How much does a sheet of roof plywood or OSB cost?

HomeGuide's material ranges are $16–$64 per sheet for plywood and $9–$60 per sheet for OSB, before installation. Thickness, grade and local lumber prices move the number, so ask your roofer which panel and thickness the per-sheet price includes.

What does it cost to replace roof decking and shingles together?

In TheRoofBill's national baseline example, an architectural shingle replacement on a 2,000 sq ft one-story footprint is about $14,000–$18,500 including a 10% decking allowance of about $1,167–$1,528. Replacing the entire deck instead, about 70 sheets at HomeGuide's $2–$5 per square foot, would add roughly $4,500–$11,200 for that line alone.

Cost figures are planning estimates based on 2026 public data (Homewyse, Angi, Fixr, BLS). They are not contractor quotes. Full disclaimer · How we calculate.