Cost Guides · 2026

Roof Underlayment Replacement Cost (2026): Felt, Synthetic & Ice

Underlayment runs about $0.05–$0.65 per sq ft for materials, and on a shingle reroof it's already in the installed price. When it's a separate line.

$0.05–$0.65

Short answer

Underlayment runs about $0.05–$0.65 per sq ft for materials, and on a shingle reroof it's already in the installed price. When it's a separate line.

Calculator

Roof cost calculator

Preset to the national labor baseline and a 2,000 sq ft home (2,240 sq ft of roof). Change any input for an itemized 2026 estimate. The link in your address bar saves your inputs.

01

Material

Model rate: $5.21–$6.82 per roof sq ft installed.

02

Roof area

Area unit

Roof surface, not floor area. One roofing square = 100 sq ft. 2,240 sq ft = 22.4 squares.

03

Roof pitch

Steeper roofs take more labor and safety setup.

04

Complexity

05

Stories

06

Old layers to tear off

Tear-off: $39–$53 per square per layer.

07

Location

State labor factor from BLS roofer wages. ZIP is optional and never stored.

+

Extras (optional)

Itemized planning estimate

Your roof bill

National baseline · 2,240 sq ft roof

Planning estimate
Materials & installation2,240 sq ft × $5.21–$6.82 × 1.00 adjustments$11,670–$15,280
Tear-off22.4 squares × $39–$53 × 1 layer$870–$1,190
Permits & disposalModel default, scaled to 1.6× at the high end$300–$480
Decking contingency10% of base, for damaged decking found mid-job$1,160–$1,530

Estimated installed total · Architectural Asphalt Shingles

$14.0k–$18.5k
Low$14,000
Typical (midpoint)$16,200
High$18,500

$630–$820 per roofing square, all in. Planning life 25–30 years.

Not included: gutters and structural repairs beyond decking.

Planning estimate only, not a contractor quote. Actual cost depends on roof condition, local requirements, and the work included.

Roof underlayment replacement cost: the short answer

If you're replacing an asphalt shingle roof, new underlayment is already inside the installed price: the old layer comes off with the shingles, and the new one goes down before they do. Fixr's underlayment replacement guide (updated January 31, 2025) puts that portion at about $800–$1,200 for a 2,000 sq ft roof. Underlayment becomes its own large line mainly on tile roofs, where the tiles are lifted, the underlayment replaced and the tiles relaid, at $2.75–$3.50 per sq ft.

The short answer

On a shingle reroof, compare the underlayment type and coverage between bids, not a separate price. The line to watch is the ice barrier: where it's required, it adds membrane at the eaves (and often valleys). TheRoofBill's calculator prices that upgrade at $500–$1,200.

What underlayment does

Underlayment is the water-resistant layer between the roof deck and the shingles or tile. It sheds water that gets past the roof covering and protects the deck during installation. The International Residential Code (section R905.1.1) sets the type and application; where the local climate table designates a history of ice damming, section R905.1.2 also requires an ice barrier at the eaves.

Synthetic vs felt vs peel-and-stick

TypeWhat it isMaterials only, per sq ft (Fixr)Typical use
Felt (asphalt-saturated)Traditional #15 or #30 felt paper$0.05–$0.50Lowest material cost
SyntheticWoven or spun polymer sheet$0.17–$0.55Common default on new shingle roofs
Rubberized, self-adheredPeel-and-stick polymer-modified bitumen membrane$0.55–$0.65Ice barrier at eaves, valleys, low slopes, penetrations

Angi's felt vs synthetic guide gives similar material ranges: $0.05–$0.45 per sq ft for felt and $0.15–$0.70 for synthetic. Labor in Fixr's guide is $0.15–$0.50 per sq ft on standard roofs. Shingle and tile manufacturers often specify which underlayments their system warranties accept, so ask your roofer what the product's warranty requires.

Underlayment scope matrix

This is where most quotes get confusing. The same word, "underlayment," can be inside a price, an upgrade, or the whole job.

SituationIs underlayment a separate line?Typical price basis
Full shingle reroofNo: included in the installed rateCompare type and coverage only
Ice barrier where code requires itSometimes listed as an upgradeLinear feet of eave × membrane width
Valleys, skylights, chimneysOften bundled with flashingPer detail or per lineal foot
Low-slope sections (2/12 to 4/12)Sometimes: code calls for double underlaymentExtra layer over that area
Tile or slate kept and relaidYes: it's the main line$2.75–$3.50 per sq ft (Fixr)
Small repairFolded into the repair pricePer repair

The double-underlayment rule for 2/12–4/12 slopes is summarized in the City of Firestone's reroof requirements under the 2018 IRC.

Don't double-count. TheRoofBill's installed rates already include standard underlayment. If you use the roof replacement cost calculator, add the ice and water shield option only for the extra membrane at eaves and valleys, not for the field underlayment.

Measure underlayment by roof area, not floor area

Underlayment covers the sloped roof surface. In the model, a 2,000 sq ft one-story footprint at a medium pitch has about 2,240 sq ft of roof. Using Fixr's ranges, materials alone for that area are:

Material over 2,240 sq ftMaterials onlyPlus labor ($0.15–$0.50/sq ft)
Felt$112–$1,120$448–$2,240
Synthetic$381–$1,232$717–$2,352
Rubberized self-adhered (whole roof)$1,232–$1,456$1,568–$2,576
Labor only—$336–$1,120

This is arithmetic on Fixr's per-sq-ft ranges, not a TheRoofBill model output. Full peel-and-stick coverage is rarely needed on a steep-slope shingle roof; it's shown for comparison. Laps and waste add material beyond the net area.

How much ice barrier a roof needs

Where it's required, the ice barrier runs from the lowest roof edge to at least 24 inches inside the exterior wall line, measured horizontally, as the Firestone handout quotes IRC R905.1.2. Overhang depth and wall thickness count, so the distance up the slope is longer than 24 inches. Fine Homebuilding's worked examples show 50½ inches up an 8/12 roof and 59⅜ inches up a 12/12 roof, each with a 12-inch overhang and a 2×6 wall.

Worked example. A simple gable with 100 lineal feet of eaves, 6/12 pitch, 12-inch overhang and a 2×6 wall needs about 47 inches of membrane up the slope (Fine Homebuilding's 6/12 example). That's about 392 sq ft of membrane, or roughly $215–$255 in materials at Fixr's rubberized range. A 36-inch roll doesn't reach, so it takes two courses. Valleys and penetrations add more. That's consistent with the $500–$1,200 installed range the calculator uses for eaves and valleys.

Detached, unheated accessory buildings are exempt from the base-code ice barrier rule; see garage roof replacement cost.

Full roof vs local repair

  • Full reroof (shingles): underlayment replaced everywhere, priced inside the job. See new roof cost.
  • Tile or slate with sound tiles: the underlayment is often the part that wears out first, so a lift-and-relay can make sense. Fixr assumes about 10% of tiles break in the process; ask about replacement tiles. See concrete vs clay tile roof cost.
  • Local leak: the repair includes a patch of underlayment. See roof repair cost.

What to ask on the quote

  1. Underlayment brand and type for the field of the roof.
  2. Where self-adhered membrane goes: eaves (how far up), valleys, penetrations, low-slope sections.
  3. Whether the shingle or tile warranty requires a specific underlayment.
  4. For tile: the lift-and-relay price per sq ft and the allowance for broken tiles.

The next step

Get your number in 60 seconds.

Answer a few quick questions and get an itemized 2026 estimate for your roof. No email, no sales calls.

Open the Roof Cost Calculator →

Based on 2026 public cost data. See the methodology.

Sources and fact-check date

Checked November 15, 2026:

More project costs are in our 2026 roof cost guides.

The next step

Get your number in 60 seconds.

Answer a few quick questions and get an itemized 2026 estimate for your roof. No email, no sales calls.

Open the Roof Cost Calculator →

Based on 2026 public cost data. See the methodology.

Frequently asked questions

How much does it cost to replace roof underlayment?

On a full shingle replacement, underlayment is part of the installed price, not an extra. Fixr's underlayment guide (updated January 31, 2025) puts it at $800–$1,200 for a 2,000 sq ft roof, about $900 on average, when the roofing is also replaced. Replacing underlayment under tile that is lifted and relaid costs far more: $2.75–$3.50 per sq ft in the same guide.

What does roof underlayment cost per square foot?

Materials only, Fixr lists felt at $0.05–$0.50, synthetic at $0.17–$0.55 and rubberized self-adhered membrane at $0.55–$0.65 per sq ft, with labor at $0.15–$0.50 per sq ft on standard roofs. Angi's felt-vs-synthetic guide gives similar material ranges: $0.05–$0.45 for felt and $0.15–$0.70 for synthetic.

Can you replace underlayment without replacing the shingles?

Not on an asphalt shingle roof in any practical way: the shingles are nailed through it. Fixr notes that underlayment-only jobs are mainly for tile, concrete and some slate roofs, where the tiles are lifted, the underlayment replaced and the tiles reinstalled.

Is ice and water shield required on the whole roof?

Usually not. Where the code requires an ice barrier, it runs from the lowest roof edge to a point at least 24 inches inside the exterior wall line. On a 6/12 roof with a 12-inch overhang and a 2×6 wall, Fine Homebuilding's example works out to 47 inches up the slope. Many roofers also add it in valleys and around penetrations.

Cost figures are planning estimates based on 2026 public data (Homewyse, Angi, Fixr, BLS). They are not contractor quotes. Full disclaimer · How we calculate.